deformations

英 [ˌdiːfɔːˈmeɪʃənz]

美 [ˌdifɔrˈmeɪʃənz]

n.  损形; 变形; 畸形; 破相; 变丑; 残废
deformation的复数

柯林斯词典

• V-ERG （使）变形;（使）成畸形;损毁…的外形
  If somethingdeformsa person's body or something else, it causes it to have an unnatural shape. In technical English, you can also say that the second thingdeforms.
  1. Bad rheumatoid arthritis deforms limbs...
     严重的类风湿性关节炎会造成四肢变形。
  2. ...the ability of a metal to deform to a new shape without cracking.
     金属重新塑形而不断裂的能力

双语例句

• It would make no difference if the bar deformations were totally inelastic.
  如果杆的变形完全是非弹性变形时这也就没有什么区别了。
• The character of a state of stress becomes more evident when we consider the deformations or strains produced.
  如若考虑一下所产生的变形或应变，则应力状态的特性便变得更明显了。
• Stress concentrations due to prestressing or other loads and to restraints or imposed deformations shall be considered.
  应考虑预加应力或其它荷载以及限制或施加变形引起的应力集中。
• The influence of inclined struts on the elastic properties under axial, bending, and shear deformations as well as the impact of axial deformation of horizontal struts were considered comprehensively.
  综合考虑了胞体中斜支柱的轴向、弯曲和剪切变形以及水平支柱的轴向变形的影响，利用最小势能原理得到了材料的弹性性能与各向异性比及相对密度的关系。
• And plane finite element method is used to simulate excavation process and calculate the corresponding deformations.
  应用平面有限元法模拟基坑开挖过程计算出各工况的变形值，与基坑实测变形进行对比分析；
• The deformations of aerated concrete block in varied initial moisture content and environment were mainly studied.
  研究了不同初始含湿量及在不同环境中的加气混凝土砌块的变形行为。
• The wing withstands vertical bending, chordwise bending and torsional deformations, and the rotor blade is considered to be capable of rigidly withstanding one order flap and lag motions.
  机翼承受垂向弯曲、弦向弯曲和扭转变形，螺旋桨旋翼的桨叶认为是刚性的并承受一阶挥舞和摆振。
• Objective The aim of this study is to measure the deformations of crowns and the failure loads of cements.
  目的探讨三种不同黏结剂对固定义齿刚性及黏结层破坏负荷的影响。
• Dial gauges, gridding lines and digital camera were used to monitor quantitatively and write down qualitatively the deformations and displacements of the models.
  采用百分表、网格线和数码相机，对模型的变形和位移进行监测和记录。
• Then the door deformations in X and Y directions are analyzed with both theoretical and real gaps.
  分别对车门在理论间隙和实测间隙下的Y向变形、X向变形进行分析。