rearward
英 [ˈrɪəwəd]
美 [ˈrɪrwərd]
adj. 后面的; 后部的
COCA.33356
牛津词典
adj.
- 后面的;后部的
at or near the back of sth- rearward seats
后面的座位
- rearward seats
柯林斯词典
- ADV 向后面;朝后面
If something moves or facesrearward, it moves or faces backwards.- ...a rearward facing infant carrier...
后向式婴儿背带 - The centre of pressure moves rearward and the aeroplane becomes unbalanced.
气压中心后移使飞机失去平衡。 - Rearwardis also an adjective.
- ...the rearward window.
后边的窗户
- ...a rearward facing infant carrier...
英英释义
noun
- direction toward the rear
- his outfit marched to the rearward of the tank divisions
adj
- directed or moving toward the rear
- a rearward glance
- a rearward movement
adv
- at or to or toward the back or rear
- he moved back
- tripped when he stepped backward
- she looked rearward out the window of the car
双语例句
- Case located in uvula and nodulus of cerebellar inferior vermis and vegetated ahead into rearward of medulla oblongata;
1例局限于下蚓部蚓垂及小结区向前侵犯延髓后缘; - ( especially of aircraft wings) angled rearward from the point of attachment.
(尤指飞机机翼)从连接点向后转变角度。 - Furthermore, the configuration of zygomatic body was observed on coronal sectional image. Results The average rearward slope angle of zygomatic-body was 80.03 °.
在冠状位截面影像上观察颧骨的形态并测量上颌牙槽嵴最颊侧点到上颌窦最外侧点的水平距离。结果颧骨的前后倾斜角度平均为80.03°,即颧骨前倾9.97°; - Remove the starter rearward from the engine, rotating the starter as necessary.
从发动机向后拆下起动机,必要时转动起动机。 - Abnormal rearward curvature of the spine, resulting in protuberance of the upper back; hunchback. overhead cam shaft
脊柱后凸,驼背脊椎不正常地向后弯曲,导致背部上方凸出;驼背上凸轮轴上部凸轮轴 - CASE REPORT The first case is subcutaneous swelling at right angle of mandible, the second case at the rearward of cervix and fine needle aspiration were performed in them.
[病例报告]给例1右下颌角处皮下肿物、例2后颈部皮下肿物均做了穿吸细胞学检查。 - Move glass carriage to vent position and remove rearward adjustment bolt from adjustment bracket.
将玻璃搬运车移至通风口位置,并从调节支架上拆卸后调节螺栓。 - On the medial femoral condyle of rabbit, the foreside of the articular cartilage were non weight-bearing area, the rearward of the articular cartilage were weight-bearing area.
兔股骨内髁前部关节软骨非负重区,后部关节软骨负重区。 - Starting at the forward end of the upper molding, force the molding onto the door panel flange and continue rearward until it is completely seated on the flange.
从上部嵌条的前末端开始,用力使嵌条到车门饰板上并且继续向后直到它完全固定在凸缘上。 - Do not want the dispute of rearward comment boss.
不要在背后议论老板的是非。